Snmp Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

SNMP Commands

system snmp trap configure <ip address>
This command configures a new or existing SNMP agent to which trap information is
forwarded. After you have issued the system snmp trap configure command to specify
the IP address of the agent, you enter the system-config [snmp-trap] mode, and then you can
configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Step 1 Format
Mode
Step 2 Format
Mode
Keyword
subnet_mask
port
community
agent
Command example:
FVS318N> system snmp trap configure 10.118.33.245
system-config[snmp-trap]> subnet_mask 255.255.255.0
system-config[snmp-trap]> port 162
system-config[snmp-trap]> community public
system-config[snmp-trap]> save
Related show command:
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
system snmp trap configure <ipaddress>
system
subnet_mask <subnet mask>
port <number>
community <community name>
agent <ipaddress>
system-config [snmp-trap]
Associated Description
Parameter to Type
The subnet mask used to determine the list of allowed SNMP
subnet mask
agents that are part of the subnet. To allow any IP address on the
network to manage the device, specify 255.255.255.0. For a
specific host, specify 255.255.255.255. To allow global access,
specify 0.0.0.0.
The SNMP port (integer) to which the trap messages are
number
forwarded. Valid numbers are from 0 to 65535.
community name The string that represents the community to which the agent
belongs. Most agents are configured to listen for traps in the public
community.
This keyword and parameter allow you change the existing agent
ipaddress
IP address that you issued to enter the system-config [snmp-trap]
mode.
show system snmp trap [agent ipaddress]
System Mode Configuration Commands
149