The Five Main Modes For Configuration Commands - NETGEAR ProSafe FVS318N Cli Reference Manual

The Five Main Modes for Configuration Commands

For the configuration commands, there are five main modes in the CLI: net, security, system,
dot11, and vpn. Chapter 2, Overview of the Configuration Commands
these modes, and each of these modes is described in detail in a separate chapter (see
Chapter 3 through
The following table lists the main configuration modes, the configuration modes, the features
that you can configure in each configuration mode, and, for orientation, the basic web
management interface (GUI) path to the feature.
Table 3. Main configuration modes
__________________________CLI________________________ ___Web Management Interface (GUI)___
Main Mode Submode
Network configuration commands
net ddns
dmz
ethernet
ipv6
ipv6_tunnel
lan
radvd
routing
wan
wan_settings NAT or Classical Routing
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Chapter 7).
Feature That You Can Configure
Dynamic DNS
DMZ for IPv4
DMZ for IPv6
VLAN assignment to LAN interface Network Configuration > LAN Setup
IPv4 or IPv4/IPv6 mode
IPv6 tunnels
IPv4 LAN settings and VLANs
LAN groups for IPv4
Secondary IPv4 addresses
Advanced IPv4 LAN settings
IPv6 LAN settings
Secondary IPv6 addresses
IPv6 LAN DHCP address pools
IPv6 RADVD and pools for the LAN
IPv6 RADVD and pools for the DMZ
Dynamic IPv4 routes
Static IPv4 routes
Static IPv6 routes
IPv4 WAN (Internet) settings
IPv6 WAN (Internet) settings
MTU, port speed, and MAC
address
Introduction
Basic Path
Network Configuration > Dynamic DNS
Network Configuration > DMZ Setup
Network Configuration > WAN Settings
Network Configuration > WAN Settings
Network Configuration > LAN Setup
Network Configuration > LAN Setup
Network Configuration > DMZ Setup
Network Configuration > Routing
Network Configuration > WAN Settings
Network Configuration > WAN Settings
11
lists all commands in