NETGEAR ProSafe FVS318N Cli Reference Manual page 234

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Keyword
destination_object_type
(continued)
resource_name
policy_permission
Associated Keyword to
Select or Parameter to Type
NetworkResource,
IPAddress, IPNetwork, or
All
(continued)
resource name
Permit or Deny
VPN Mode Configuration Commands
234
Description
• IPNetwork. The policy is applied to an IPv4
or IPv6 network address. You need to issue
the following keywords and their associated
parameters and keywords:
- policy_name
- ip_version
- policy_address and
policy_mask_length or
policy_address6 and
policy_ipv6_prefix_length
(depending on the setting of the
ip_version keyword)
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
• All. The policy is applied to all addresses.
You need to issue the following keywords and
their associated parameters and keywords:
- policy_name
- ip_version
- start_port and end_port
- service_type
- policy_permission
- policy_owner if the policy_type
keyword is set to Group or User.
The name of a resource that you configured
with the vpn sslvpn resource add
This keyword and parameter apply only if the
policy is for a network resource.
Specifies whether the policy permits or denies
access.
command.