Table of Contents
Advertisement
Wireless Access Point User Guide
Auto Config/Update
The Auto Config/Update screen provides two (2) features:
•
Auto Config - The Access Point will configure itself by copying data from another (compatible) Access
Point.
•
Auto Update - The Access Point will update it Firmware by downloading the Firmware file from your
FTP Server.
Data - Auto Config/Update Screen
Auto Config
Perform Auto Configu-
ration on this AP next
restart
Figure 59: Auto Config/Update Screen
If checked, this AP will perform Auto Configuration the
next time it restarts.
•
The wired LAN (NOT the Wireless LAN) will be
searched for compatible APs.
•
If a compatible AP is found, its configuration is
copied. If more than one compatible AP exists,
the first one found is used.
•
Some data cannot be copied:
The IP address is not copied, and will
o
not change.
The operating mode ( Repeater, Bridge,
o
etc) is not copied, and will not change.
Note: This checkbox is automatically disabled, so the
Auto-configuration is only performed once.
78
Advertisement
Table of Contents
