Table of Contents
Advertisement
Chapter 3
Access Point Setup
This Chapter provides details of the Setup process for Basic Operation of your
Wireless Access Point.
Overview
This chapter describes the setup procedure to make the Wireless Access Point a valid device on your LAN,
and to function as an Access Point for your Wireless Stations.
Wireless Stations may also require configuration. For details, see Chapter 4 - Wireless Station Configuration.
The Wireless Access Point can be configured using either the supplied Windows utility or your Web Browser
Setup using the Windows Utility
A simple Windows setup utility is supplied on the CD-ROM. This utility can be used to assign a suitable IP
address to the Wireless Access Point. Using this utility is recommended, because it can locate the Wireless
Access Point even if it has an invalid IP address.
Installation
1. Insert the supplied CD-ROM in your drive.
2. If the utility does not start automatically, run the SETUP program in the root folder.
3. Follow the prompts to complete the installation.
Main Screen
•
Start the program by using the icon created by the setup program.
•
When run, the program searches the network for all active Wireless Access Points, then lists them on
screen, as shown by the example below.
Wireless Access Points
The main panel displays a list of all Wireless Access Points found on the network. For each Access Point,
the following data is shown:
Server Name
The Server Name is shown on a sticker on the base of the device.
The IP address for the Wireless Access Point.
IP address
Figure 6: Management utility Screen
3
9
Advertisement
Table of Contents
