Table of Contents
Advertisement
Chapter 3
Access Point Setup
This Chapter provides details of the Setup process for Basic Operation of
your Wireless Access Point.
Overview
This chapter describes the setup procedure to make the Wireless Access Point a valid device on
your LAN, and to function as an Access Point for your Wireless Stations.
Wireless Stations may also require configuration. For details, see Chapter 4 - Wireless Station
Configuration.
The Wireless Access Point can be configured using your Web Browser.
Setup using a Web Browser
Your Browser must support JavaScript. The configuration program has been tested on the
following browsers:
MAC OS X/Linux
Windows98SE/ME/2000(SP4)/XP SP2/Vista/7
Setup Procedure
Before commencing, install the Wireless Access Point in your LAN, as described previously.
1.
Check the Wireless Access Point to determine its Default Name. This is shown on a label
on the base or rear
2.
Use a PC which is already connected to your LAN, either by a wired connection or another
Access Point.
Until the Wireless Access Point is configured, establishing a Wireless connection to it
may be not possible.
If your LAN contains a Router or Routers, ensure the PC used for configuration is on
the same LAN segment as the Wireless Access Point.
3.
Start your Web browser.
4.
In the Address box, enter "HTTP://" and the IP Address of the 11N Wireless Access Point,
as in this example, which uses the Wireless Access Point's default IP Address:
HTTP://192.168.0.1
5.
You should then see a login prompt, which will ask for a User Name and Password.
Enter admin for the User Name, and password for the Password.
These are the default values. The password can and should be changed. Always enter the
current user name and password, as set on the Admin Login screen.
3
7
Hide quick links:
Advertisement
Table of Contents
