Docking And Undocking The Mx3Plus; Maintenance; Cleaning - Honeywell MX3Plus Cradle Reference Manual

Docking and Undocking the MX3Plus

Lower the MX3Plus straight into the cradle, tilt it forwards and then let it rest backwards into the cradle.
Ensure that the mobile device is properly seated on the charging contacts.
The CHGR LED on the MX3Plus will illuminate green when the device is correctly seated in a powered cradle.
To remove the MX3Plus, tilt it forward slightly and lift it straight up out of the cradle.
Note: Do not "slam" or slide the MX3Plus sideways into the cradle. Damage may result.

Maintenance

Inspect the rubber feet and replace them if missing, broken or cracked. Check the cradle regularly for excessive wear at
pressure points. If the cradle is mounted to a stable surface, check surface mounting connections periodically and re-tighten as
necessary.
Check the cradle bracket connection periodically and re-tighten as necessary.
If the cradle becomes cracked or broken at any time, it must be taken out of service and replaced. Contact Technical
Assistance for a replacement cradle.
There are no serviceable parts in the desktop cradle. Do not attempt to open the unit.

Cleaning

Do not use paper towels or harsh-chemical-based cleaning fluids since they may result in damage to the surfaces and/or
battery charging terminals (pins).
Use a clean soft cloth to wipe any dirt, moisture or grease from the MX3Plus, spare battery packs, charging contacts (pins) or
the cradle.
Do not use any liquid to clean the battery pack, MX3Plus, cradle, or charging pockets. Spray or dampen the cleaning cloth with
liquids/sprays. If possible, clean only those areas which are soiled.
Lint/particulates can be removed from the connectors, charging terminals and charging/docking pockets with clean, filtered
canned air.
2-8