5.3 PRINTER ENGINE SERVICE MODE [ALL MODELS]
5.3.1 SERVICE MODE TABLE
Notation
[range / default / step]
italics
DFU
Japan only
SP1-xxx: Feed
1003
Regist sag
Adjusts the relay clutch timing at registration. Relay clutch timing determines
the amount of paper buckle at registration. (A "+" setting causes more
buckling.)
1003 1 Cassette
1003 2 Multi tray [By-pass]
1003 3 Duplex Tray
1104
Fusing control
Use phase control if the room lights flicker when the fusing lamp starts.
Defaults: North America – Normal (On/off control), Europe – Phase
1105
Fusing Temp.
Adjusts the fusing temperatures for printing and standby mode.
1105 1
Fusing temp
Adjusts the fusing temperature for printing on normal paper.
1105 2
Fusing T Stand
Adjusts the fusing temperature for standby mode.
1106
Fusing T Display
1106 1 Displays the current fusing temperature.
1902
OHP clutch rt
Selects the number of rotations for the bypass feed roller when the paper type
is set to "Transparencies".
If jams occur when transparencies are being used, change the setting to 2.
SM
PRINTER ENGINE SERVICE MODE [ALL MODELS]
What it means
Example: [-9 ~ +9 / +3.0 / 0.1 mm step]. The setting can be
adjusted in the range ±9, value reset to +3.0 after an NVRAM
reset, and the value can be changed in 0.1 mm steps with
each key press.
Comments added for reference.
Denotes "Design or Factory Use". Do not change this value.
The feature or item is for Japan only. Do not change this
value.
[–8 mm ~+8 mm/0/2 mm step]
[–8 mm ~+8 mm/0/2 mm step]
[–8 mm ~+8 mm/0/2 mm step]
Normal, Phase control
[150 ~ 200/ 170 / 5 deg.] DFU
[140 ~ 175 / 168 / 1 deg.] DFU
G112 Series: 1 = 1 rotation, 2 = 2 rotations
G116 Series: 1 = 1 rotation, 2 = 2 rotations
5-3
G112/G113/G116/G094/G095/G091