General; Precautions On Disassembly [All Models]; Replacement And Adjustment - Ricoh G112 Service Manual

3. REPLACEMENT AND ADJUSTMENT


CAUTION
Turn off the main power switch and unplug the machine before attempting
any of the procedures in this section.
The Replacement and Adjustment procedures in this section are for all models,
unless otherwise specified. Differences are shown with the machine code.
NOTE: This manual uses these symbols.
: See or Refer to
3.1

GENERAL

3.1.1 PRECAUTIONS ON DISASSEMBLY [ALL MODELS]

Use extreme caution when removing and replacing components. The cables in the
machine are located very close to moving parts. Proper cable routing is a must.
Before removing any component from the machine, note any cable routings that
may be affected. After components have been removed, any cables that have been
displaced during the procedure must be rerouted as closely as possible to their
original positions.
Before servicing the machine:
1. Verify that documents are not stored in memory.
2. Remove the toner cartridge before you remove parts.
3. Unplug the power cord.
4. Work on a flat and clean surface.
5. Replace with authorized components only.
6. Do not force plastic material components.
Ensure that all components are returned to their original positions, when you have
completed service activity.
SM
 : Screws  : Connector
3-1
GENERAL
G112/G113/G116/G094/G095/G091