Unsolicited Heartbeat Interval - Motorola LI2208 Product Reference Manual

7 - 28 LI2208 Product Reference Guide

Unsolicited Heartbeat Interval

Parameter # F8h 04h 5Eh
The linear imager supports sending Unsolicited Heartbeat Messages to assist in diagnostics. To enable this
feature and set the desired unsolicited heartbeat interval, scan one of the time interval bar codes below, or
scan Set Another Interval followed by four numeric bar codes from
(scan sequential numbers that correspond to the desired number of seconds).
Scan Disable Unsolicited Heartbeat Interval to turn off the feature.
The heartbeat event is sent as decode data (with no decode beep) in the form of:
MOTEVTHB:nnn
where nnn is a three digit sequence number starting at 001 and wrapping after 100.
NOTE For correct operation, you must disable Low Power Mode (see
10 seconds
Set Another Interval
Appendix E, NUMERIC BAR CODES
Low Power Mode on page
1 minute
*
Disable Unsolicited Heartbeat Interval
7-13).