Connecting A Keyboard Wedge Interface - Motorola LI2208 Product Reference Manual

6 - 2 LI2208 Product Reference Guide

Connecting a Keyboard Wedge Interface

Keyboard Wedge Connection with Y-cable
Figure 6-1
NOTE Interface cables vary depending on configuration. The connectors illustrated in
The connectors may be different than those illustrated, but the steps to connect the scanner remain the
same.
To connect the Keyboard Wedge interface Y-cable:
Turn off the host and unplug the keyboard connector.
1.
Attach the modular connector of the Y-cable to the cable interface port on the linear imager.
2.
Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.
3.
Connect the round female DIN keyboard connector of the Y-cable to the keyboard connector.
4.
If needed, attach the optional power supply to the connector in the middle of the Y-cable.
5.
Ensure that all connections are secure.
6.
Turn on the host system.
7.
Select the Keyboard Wedge host type by scanning the appropriate bar code from
8.
Parameters on page
NOTE
To modify any other parameter options, scan the appropriate bar codes in this chapter.
9.
6-4.
The Auto-Host Detect Cable feature automatically detects the host interface type
the default setting. If the default (*) does not meet your requirements, scan
Compatibles on page 6-4.
Figure are examples only.
Keyboard Wedge Host
and uses
IBM PC/AT & IBM PC