Motorola LI2208 Product Reference Manual page 326

12 - 6 LI2208 Product Reference Guide
Troubleshooting (Continued)
Table 12-1
Problem
Host Displays
Host displays scanned data
incorrectly.
Trigger
Nothing happens when the trigger is
pulled, and/or the red illumination
does not appear when the trigger is
pulled.
NOTE If after performing these checks the symbol still does not scan, contact the distributor or contact Motorola
Solutions Support. See
Possible Causes
Linear imager scanner is not
programmed to work with the
host.
No power to the linear imager.
Interface/power cables are loose.
Linear imager scanner is
disabled.
page xvii for contact information.
Possible Solutions
Ensure the proper host is selected.
Scan the appropriate host type
programming bar code.
For RS-232, ensure the linear imager's
communication parameters match the
host's settings.
For a USB HID keyboard or Keyboard
Wedge configuration, ensure the
system is programmed for the correct
keyboard type and language, and turn
off the CAPS LOCK key.
Ensure editing options (e.g., ADF,
UPC-E to UPC-A Conversion) are
properly programmed.
Check the linear imager's host type
parameters or editing options.
Ensure all power (if applicable) and
cable connections are secure.
Check the system power. If the
configuration requires a power supply,
re-connect the power supply.
Ensure all power (if applicable) and
cable connections are secure.
Check for loose cable connections and
re-connect cables.
For IBM-468x mode, enable the linear
imager via the host interface.