Health Care Linear Imagers; Cleaning The Health Care Linear Imager; Daily Cleaning And Disinfecting; Monthly 'Deep Cleaning' Maintenance - Motorola LI2208 Product Reference Manual

Health Care Linear Imagers

Cleaning the Health Care Linear Imager

The LI2208-HC0000BZZWW health care design allows safe cleansing of the product plastics with a variety of
cleaning products and disinfectants. If required, wipe the digital scanner with the following list of approved
cleansers:
•
Isopropyl alcohol
•
Bleach/sodium hypochlorite
•
Hydrogen peroxide
•
Gentle dish soap and water
IMPORTANT Cleansers that contain active ingredients not listed above should not be utilized on the
LI2208-HC0000BZZWW.

Daily Cleaning and Disinfecting

Following are the cleaning and disinfecting instructions for environments that require daily or more frequent
cleaning to prevent the spread of germs, including healthcare workers who need to disinfect their scanner after
each patient visit and retail and other shift workers who share devices.
Dampen a soft cloth with one of the approved cleaning agents listed above or use pre-moistened wipes.
1.
Gently wipe all surfaces, including the front, back, sides, top and bottom. Never apply liquid directly to the
2.
scanner. Be careful not to let liquid pool around the scanner window, trigger, cable connector or any other
area on the device.
Be sure to clean the trigger and in between the trigger and the housing (use a cotton-tipped applicator to
3.
reach tight or inaccessible areas).
Immediately dry the scanner window after cleaning with a soft non-abrasive cloth to prevent streaking.
4.
Allow the unit to air dry before use.
5.

Monthly 'Deep Cleaning' Maintenance

Keep your Motorola scanner in good working order with a regular comprehensive cleaning routine to remove
the natural build-up of dirt that occurs with everyday use on connectors and the scanner exit window as well as
the main surfaces of the device.
Housing: Follow the instructions for daily cleaning and disinfecting above to give the housing a general
1.
cleaning.
Scanner exit window: Wipe the scanner exit window with a lens tissue or other material suitable for
2.
cleaning optical material such as eyeglasses.
Scanner connector:
3.
Dip the cotton portion of a cotton-tipped applicator in isopropyl alcohol.
a.
Rub the cotton portion of the cotton-tipped applicator back-and-forth across the connector on the
b.
Motorola scanner. Do not leave any cotton residue on the connector.
Repeat at least 3 times.
c.
Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt near the connector
d.
area.
Use a dry cotton tipped applicator and repeat steps c, d and e (do not apply alcohol as directed in any
e.
of these steps).
MAINTENANCE, TROUBLESHOOTING & TECHNICAL SPECIFICATIONS 12 - 3