Stop Bit Select; Check Receive Errors - Motorola LI2208 Product Reference Manual

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. The number of stop bits selected
(one or two) depends on the number the receiving terminal is programmed to accommodate. Set the number of
stop bits to match host device requirements.
2 Stop Bits

Check Receive Errors

Select whether or not the parity, framing, and overrun of received characters are checked. The parity value of
received characters is verified against the parity parameter selected above.
*
Check For Received Errors
(Enable)
RS-232 INTERFACE
*
1 Stop Bit
Do Not Check For Received Errors
(Disable)
4 - 9