Step 5 - Dress The Engage Cable - enphase M215 Installation And Operation Manual

Step 5 – Dress the Engage Cable
a. Attach the Engage Cable to the mounting rail using clips or tie wraps.
NOTE: There are two release-holes in the drop connector on the cable. These are not for
mounting but are used to disconnect the connector. Keep these release holes clear and
accessible.
b. Dress any excess in loops so that the Engage Cable does not contact the roof.
There are several ways to support the cable. One method is to place tie wraps or clips on either
side of the connector. Use one or two additional clips, tie wraps, or other support scheme to
secure the cable between connectors.
13
release holes
Copyright © 2012 Enphase Energy
M215 Installation and Operation
141-00021 Rev 01