Enphase Microinverter Installation; Compatibility And Capacity; Electrical Compatibility; Capacity - enphase M215 Installation And Operation Manual

Enphase Microinverter Installation

Follow the instructions in this section to install Enphase M215™ Microinverters.
WARNING: Be aware that only qualified personnel should connect the Enphase Microinverter
to the electricity network.
WARNING: Be aware that installation of this equipment includes risk of electric shock. Normally
earthed conductors may be unearthed and energised when an earth fault is indicated.

Compatibility and Capacity

The Enphase M215 Microinverters are electrically compatible with most 60-cell PV modules. For more
information, see Technical Data on page 24 of this manual.
WARNING: The M215 may be paired only with a 60-cell PV module.
Refer to the Enphase website (http://www.enphase.com/support/downloads) for a list of electrically compatible
PV modules and approved mounting rail systems. To ensure mechanical compatibility, be sure to order the
correct connector type for both microinverter and PV module from your distributor.

Electrical Compatibility

Model Number
M215-60-230-S22

Capacity

Service type
230V single-phase
400V three-phase
7
Works with PV Module Type
60 cell
Maximum number of M215s per 20 amp AC Branch Circuit
Copyright © 2012 Enphase Energy
M215 Installation and Operation
PV Module Connector Type
MC-4 Type 2 Locking
Max M215s per AC branch circuit
17
27
141-00021 Rev 01