Table of Contents
Advertisement
Step 6: Dress the Engage Cable
NOTE: Adhere to the following requirements:
•
Do not expose the cable connections to directed, pressurized liquid (water jets, etc.).
•
Do not expose the cable connections to continuous immersion.
•
Do not expose the AC connector to continuous tension (e.g., tension due to pulling or
bending the cable near the connection)
•
Use only the connectors and cables provided.
•
Do not allow contamination or debris in the connectors.
•
Use the cable and connectors only when all parts are present and intact.
a. Attach the Engage Cable to the PV racking using the
cable clips, or you may use tie wraps. The cable clips
are designed so that the cable from the microinverter
can also be dressed into the clip underneath the
Engage Cable.
NOTE: There are two release-holes in the drop
connector on the cable. These are not for mounting
but are used to disconnect the connector. Keep
these release holes clear and accessible.
b. Dress the Engage Cable so that it does not contact the
roof.
There are several ways to support the cable. One
method is to place tie wraps or clips on either side of the
connector. Use one or two additional clips, tie wraps, or
other support scheme to secure the cable between
connectors.
NOTE: When looping the Engage Cable, do not
form loops smaller than 4.75 inches (12 cm) in diameter.
WARNING: Tripping Hazard. Loose cables can become a tripping hazard. Dress the
Engage Cable to minimize tripping potential.
19
2015 Enphase Energy Inc. All rights reserved.
C250 System Installation and Operation
release holes
141-00025 Rev 03
Advertisement
Table of Contents
