Step 1: Position The Iq Cable; Step 2: Position The Junction Box - enphase IQ8P Installation And Operation Manual

Microinverters

Hide thumbs Also See for IQ8P:

Table of Contents

Vertical mount

Step 1: Position the IQ Cable

A. Plan each cable segment to allow drop connectors on the IQ Cable to align with each PV

module. Allow extra length for slack, cable turns, and any obstructions.

B. Mark the approximate centers of each PV module on the PV racking.

C. Lay out the cabling along the installed racking for the AC branch circuit.

D. Cut each segment of cable to meet your planned needs.

WARNING: When transitioning between rows, secure the cable to the rail to prevent

cable damage or connector damage. Do not count on the connector to withstand

tension.

A. Verify that the AC voltage at the site is within range.

240 VAC split-phase

220 VAC single-phase

220 VAC three-phase

NOTE: All installations require that you use the Enphase IQ Gateway to commission the

microinverters to propagate correct grid profile settings. This will also ensure that the

microinverter's firmware is upgraded whenever a newer version is available.

B. Install a junction box at a suitable location on the racking.

Service type and voltage: L1-L2

Enphase IQ8P Microinverters

>300 mm

211 to 264 VAC

198 to 242 VAC

January 2024

IOM-00002-1.0

Table of Contents