Bit Switches; System Switches - Ricoh M052 Service Manual

4.3 BIT SWITCHES

Do not adjust a bit switch or use a setting that is described as "Not used", as this may
cause the machine to malfunction or to operate in a manner that is not accepted by
local regulations. Such bits are for use only in other areas, such as Japan.
Default settings for bit switches are not listed in this manual. Refer to the System
Parameter List printed by the machine.

4.3.1 SYSTEM SWITCHES

System Switch 00 [SP No. 1-101-001]
No FUNCTION
Dedicated transmission
0 parameter programming
0: Disabled, 1: Enabled
1 Not used
Technical data printout on the
Journal
2
0: Disabled
1: Enabled
SM
COMMENTS
Set this bit to 1 before changing any dedicated
transmission parameters.
This setting is automatically reset to "0" after
turning off and on.
Do not change
1: Instead of the personal name, the following data
are listed on the Journal for each G3
communication.
43
Bit Switches
M381