Ricoh M052 Service Manual page 517

Code Meaning
No post-message
0-07 response from the other
end after a page was sent
The other end sent RTN or
PIN after receiving a page,
0-08
because there were too
many errors
Non-standard post
0-14 message response code
received
SM
Suggested Cause/Action
Check the line connection.
Replace the FCU.
The other end may have jammed or run out of
paper.
The other end user may have disconnected
the call.
Check for a bad line.
The other end may be defective; try sending to
another machine.
Check the line connection.
Replace the FCU.
The other end may have jammed, or run out of
paper or memory space.
Try adjusting the tx level and/or cable
equalizer settings.
The other end may have a defective
modem/FCU; try sending to another machine.
Check for line problems and noise.
Cross reference
Tx level - NCU Parameter 01 (PSTN)
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program
Mode
Incompatible or defective remote terminal; try
sending to another machine.
Noisy line: resend.
Try adjusting the tx level and/or cable
equalizer settings.
Replace the FCU.
Cross reference
See error code 0-08.
5
Error Codes
M381