Ricoh M052 Service Manual page 459

Rev. 03/14/2012
875 Delete All error 2: Data area
An error occurred while the machine
deleted data from the HDD.
D
Note: The source of this error is the
Data Overwrite Security Unit D362
running from an SD card.
876 D Log data abnormal
An error was detected in the
handling of the log data at power on
or during machine operation. This
can be caused if you turn the
machine off while it is operating.
Data Overwrite Security SD card error
The 'all delete' function did not
877 D
execute but the Data Overwrite
Security Unit (D362) is installed
and activated.
TPM electronic recognition error
The main machine firmware failed to recognize
878 D
TPM because USB flash is not operating or a
system module was updated incorrectly.
Authentication area error
Authentication application error is detected.
881 D
899 Software error
⇒
CTL
A software error occurred in the GW
D
controller.
SM
Error data in an authentication application reaches the management
limit.
Turn the main switch off/on,
and try the operation again.
Software error. Update the
firmware
NVRAM defective
HDD defective
Replace the NVRAM
Reinstall the DOS from the SD
card
SD card defective
Replace the
controller board
Cycle the machine off/on.
Update Controller firmware.
Controller board defective.
6-27
Service Call Conditions
M052/M053/M054