Ricoh M052 Service Manual page 560

Bit Switches
Conditions for printing the
protocol dump list
6 0: Print for all communications
1: Print only when there is a
communication error
Priority given to various types
of remote terminal ID when
printing reports
7 0: RTI > CSI > Dial label > Tel.
Number
1: Dial label > Tel. number >
RTI > CSI
System Switch 0A [SP No. 1-101-011]
No FUNCTION
Automatic port selection
0
0: Disabled, 1: Enabled
1-3 Not used
Dialing on the ten-key pad
when the external telephone is
4
off-hook
0: Disabled 1: Enabled
On hook dial
5
0: Disabled 1: Enabled
6-7 Not used
M381
This switch becomes effective only when system
switch 00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol
dump list only for communications with errors.
NOTE: The memory size is limited. Use this bit
switch only when some log reports are necessary.
This bit determines which set of priorities the
machine uses when listing remote terminal names
on reports.
Dial Label: The name stored, by the user, for the
Quick/Speed Dial number.
COMMENTS
When "1" is selected, a suitable port is
automatically selected if the selected port is not
used.
NOTE: This bit is useful if all communication lines
at a customer site are not same quality.
Do not change these settings.
0: Prevents dialing from the ten-key pad while the
external telephone is off-hook. Use this setting
when the external telephone is not by the
machine, or if a wireless telephone is connected
as an external telephone.
1: The user can dial on the machine's ten-key pad
when the handset is off-hook.
0: On hook dial is disabled.
Do not change the factory settings
48 SM