Sd Card Appli Move; Overview - Ricoh M052 Service Manual

2.8.2 SD CARD APPLI MOVE

The PostScript3 application and fonts cannot be moved to another SD card. However,
other applications can be moved onto the PostScript3 SD card.

Overview

The service program "SD Card Appli Move" (SP5-873) lets you copy application programs from
one SD card to another SD card.
SD slot 1 (upper ) is used to store application programs. But there are two possible applications
(Security Card (Data Overwrite Security and HDD Encryption Unit), IPDS). You cannot run
application programs from Slot 2. However you can move application programs from SD slot 2
(lower slot) to SD slot 1 (upper slot) with the following procedure.
Make sure that the target SD card has enough space.
1. Enter SP5873 "SD Card Appli Move".
2. Then move the application from the SD Card in SD slot 2 (lower slot) to the SD Card in SD
slot 1 (upper slot).
Do steps 1-2 again if you want to move another application program.
3. Exit the SP mode.
Be very careful when you do the SD Card Appli Move procedure:
The data necessary for authentication is transferred with the application program from an
SD card to another SD card. Authentication fails if you try to use the SD card after you copy
the application program from one card to another card.
Do not use the SD card if it has been used before for other purposes. Normal operation is
not guaranteed when such an SD card is used.
Keep the SD card in a safe place after you copy the application program from one card to
another card. This is done for the following reasons:
1) The SD card can be the only proof that the user is licensed to use the application
program.
2) You may need to check the SD card and its data to solve a problem in the future.
SM 2-27
Controller Options
M052/M053/M054