Exerpeutic 1111 Owner's Manual page 14

Tool:
Allen Wrench S6
Multi Hex Tool with
Phillips Screwdriver
4. Seat Sliding Tube, Back/Seat Support Bracket, and Handlebar Installation
Remove eight M8x15 Bolts (23) and eight Ø8 Washers (24) from the Back/Seat Support
Bracket (1) and Seat Sliding Tube (15). Remove bolts with the Allen Wrench provided.
Insert the Seat Sliding Tube (15) into the Bushings (54) of the Rear Main Frame (3).
Attach the Seat Sliding Tube (15) to the Back and Seat Support Bracket (1) with eight
M8x15 Bolts (23) and eight Ø8 Washers (24) that were removed. Tighten bolts with the
Allen Wrench provided.
Adjust the seat position and insert the Round Knob (17), M12x33 Triangle Knob (77), and
M12x27 Triangle Knob (66). Turn the Round Knob (17), M12x33 Triangle Knob (77), and
M12x27 Triangle Knob (66) in the clockwise direction to tighten.
Attach the Handlebar (13) onto the Back and Seat Support Bracket (1) with two M8x45 Bolts
(70), two Ø8 Curve Washers (25), two Ø8 Washers (24), and two M8 Cap Nuts (32).
Tighten bolts with the Multi Hex Tool with Phillips Screwdriver provided.
Connect the Middle Section Hand Pulse Sensor Wires (55) from the Rear Main Frame (3) to
the Hand Pulse Sensor Wire (68) from the Handlebar (13).
Hardware:
2 Cap Nuts (M8)
2 Bolts (M8x45) 2 Curve Washers (Ø8) 2 Washers (Ø8)
13