11
SERVICE WORK ON THE CHASSIS
11.38
Checking the rubber grip
11.39
Additionally securing the rubber grip
11.40
Adjusting basic position of clutch lever
Main work
–
Check the throttle cable routing.
The throttle cable must be routed behind the handlebar, behind the coolant
hose and left on the frame.
»
If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
V00218-01
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage, wear, and looseness.
»
If a rubber grip is damaged, worn, or loose:
–
Change the rubber grip.
Grip adhesive (00062030051) (
–
Additionally secure the rubber grip. (
401197-01
Preparatory work
–
Check the rubber grip. (
Main work
–
Secure the rubber grip at two locations with the retaining wire.
Securing wire (54812016000)
Wire twister forceps (U6907854)
The twisted wire ends face away from the palms and are bent in toward the
rubber grip.
401198-01
–
Adjust the basic position of the clutch lever to the size of the rider's hand using
adjusting screw
Info
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
602653-11
Do not make any adjustments while riding!
(
p. 43)
p. 39)
p. 49)
1
.
p. 88)
p. 49)
49