Vocal Setup 1; Vocal Setup 2 - Korg PA 80 User Manual

16-10 Global edit environment
Page 18 - Vocal Setup 1
PAGE 18 - VOCAL SETUP 1
Note: This page appears only if you selected Mode = Vocal on
"Page 17 - Vocal/Guitar Mode".
This page is where you can program the Vocal Harmony
effect.
Gbl:VocalSetup 1
HarmKbd:Aut LeadVol:120
HarmVol:127 FX Send:127
HarmOct:+1
HarmLo:F#3
HarmKbd (Harmony Keyboard Mode)
This parameter sets the Chord Scanning mode for the Har-
monizer.
On Chords for the Harmony effect are detected
according to the selected Chord Scanning
mode (see "Chord Recognition Mode" on
page 9-12). When the selected Chord Scanning
mode is UPPER, chords are recognized above
the Split Point; when it is LOWER, chords are
recognized below the Split Point.
Off Chords played on the keyboard are not used
for the Harmony effect. Chords can still be
received from the MIDI, the Song or the Back-
ing Sequence tracks.
Lead Volume
Volume of the direct signal (voice).
Harmony Volume
Volume of the Harmony notes.
FX Send
Level of the direct signal sent to the FX processors.
Harmony Octave
Octave transpose for the Harmony notes played on the key-
board. This parameter does not affect notes coming from the
MIDI IN or the Sequencer.
Harmony Lower Memory
This parameter sets how the MEMORY button affects the
Harmony notes.
On The MEMORY button affects the Harmony
notes.
Off The MEMORY button does not affect the Har-
mony notes.
Harmony Low/High
These parameters set the lower and higher note of the Har-
mony range. Notes played outside this range are automati-
cally transposed to fit this range.
These parameters are only for notes played on the keyboard.
They don't affect notes coming from the MIDI IN or the
Sequencer.
HarLowM:On
HarmHi:C6
PAGE 19 - VOCAL SETUP 2
Note: This page appears only if you selected Mode = Vocal on
"Page 17 - Vocal/Guitar Mode".
This page contains parameters for the Tone and Compressor
effects.
Gbl:VocalSetup 2
TONE:On
High:+01
Medium:+00
Low:+01
Tone
The Tone effect is a 3-band equalizer. Use it to tweak the
sound quality, by boosting/cutting frequencies.
Compressor
Use the compressor to make the dynamics more uniform.
Use the Sensitivity parameter to set the minimal threshold
before the Compressor enters. The Attack and Release
parameters set the speed of the Compressor entering or exit-
ing.
Note: If the Input stage is in clipping (red-colored SIGNAL
LED), the compressor cannot avoid clipping. Try to reduce the
GAIN level.
Effect Parameter
Tone Low
Middle
High
Compressor Sensitivity
Attack
Release
COMPRES:On
Sens:08
Attack:05
Release:07
Value
±15
±15
±15
0-30
0-10
0-10