Vocal Setup 3; Guitar Setup 1 - Korg PA 80 User Manual

PAGE 20 - VOCAL SETUP 3
Note: This page appears only if you selected Mode = Vocal on
"Page 17 - Vocal/Guitar Mode".
In this page you can assign a chorus, delay, or reverb effect to
the FX1 and FX2 processors.
Gbl:VocalSetup 3
FX1:Chorus
Speed:10
Depth:15
Level:10
FX1
Effect processor 1. You can assign a Chorus or a Delay to this
processor.
Chorus A Chorus is a modulating effect, adding a sense
of depth to the sound. Speed sets the modulat-
ing speed, while Depth is the efficacy of the
effect on the sound. Level is the general level of
the effect.
Delay The Delay is a fading-out repetition of the
sound. Use Feedback to set the number of rep-
etitions, Time for the speed of the delay, Level
to set the general level of the effect.
FX2
Effect processor 2. You can assign one of two Reverbs of dif-
ferent sizes to this processor.
Hall, Room Reverbs of different sizes. Use the Tone param-
eter to program the high-frequencies decay
(higher values mean a more reflective room).
Time sets the Reverb's decay time. Level is the
general level of the effect.
Effect Parameter
Chorus Speed
Depth
Level
Delay Feedback
Time
Level
Hall, Room Tone
Time
Level
FX2:Hall
Tone:10
Time:14
Level:10
Value
0-30
0-30
0-30
0-30
0-30
0-30
0-10
0-30
0-30
Global edit environment
Page 20 - Vocal Setup 3
PAGE 18 - GUITAR SETUP 1
Note: This page appears only if you selected Mode = Guitar on
"Page 17 - Vocal/Guitar Mode".
In the Guitar Setup 1 page, you can select a Tone (EQ) and a
preamp effect.
Gbl:Gtr Setup 1
TONE:On
High:+10
Medium:+00
Low:+10
Tone
The Tone effect is a 3-band equalizer. Use it to tweak the
sound quality, by boosting/cutting frequencies.
Drive
Drive processor. You can assign a Compressor, Overdrive or
Distortion effect to this processor.
Overdrive The Overdrive effect simulates the preamp sat-
uration of a tube guitar preamp. The Gain
parameter is the amount of gain pumped into
the preamp, while the Level is the general level
of the effect.
Distortion This one is a digital distortion; very similar to
the Overdrive, but with a less "round" quality.
Compressor Use the compressor to avoid signal peaks (and
thus clipping) or missing notes. Use the Sensi-
tivity parameter to set the minimal threshold
before the Compressor enters. The Attack and
Release parameters set the speed of the Com-
pressor entering or exiting.
Note: If the Input stage is in clipping (red-col-
ored SIGNAL LED), the compressor cannot
avoid clipping. Try to reduce the GAIN level.
Effect Parameter
Tone Low
Middle
High
Overdrive, Gain
Distortion
Level
Compressor Sensitivity
Attack
Level
16-11
DRIVE:OvDrv
Gain:+10
Level:127
Value
±15
±15
±15
0-30
0-30
0-30
0-10
0-30