Setup; Turning The Power On/Off; Connecting The Ac Adapter; Turning The Power On - Korg KROSS Operation Manual

Turning the power on/off

The KROSS can be powered either by an AC adapter or by
using batteries.

Connecting the AC adapter

1. Make sure that the power is turned off. Make sure
that nothing is shown on the display, and that the
LEDs are unlit.
2. Connect the DC plug of the included AC adapter to
the power supply jack (DC9V) on the KROSS's rear
panel.
You must only use the included AC adapter. Using any
other AC adapter might cause malfunctions.
3. Connect the AC adapter to an AC outlet.
Be sure to use an AC outlet of the correct voltage for
your adapter.
4. Use the cord hook of the KROSS to fasten the AC
adapter cord so that it will not be unplugged
accidentally.
Power supply jack (DC9V)
Power button Cable hook
DC plug

Setup

Turning the power on

1. Turn the KROSS's VOLUME knob
all the way to the left so that the
volume is down.
If any external equipment, such as a
monitor amplifier is connected, lower
their volume as well and then turn off
their power.
2. On the rear panel of the KROSS, hold
down the power button until the power
turns on. Keep holding down the button
until the display lights up.
The display will show the model name and
software version.
With the factory settings, the auto power-off function of
the KROSS is enabled; immediately after you start up,
the following message will appear, indicating the time
until the power will turn off automatically.
If you disable the auto power-off function, this message
is not displayed. (see "Auto power-off function" on
page 16)
AC adapter 3. Turn on the power of the external equipment that's
(Included)
connected to the KROSS's AUDIO OUTPUT L/
MONO and R jacks, such as a monitor amplifier.
4. Use the KROSS's VOLUME knob and the volume
controls of your external equipment to set the volume
to a suitable level.
to an AC outlet
1
2
15