The Direct Fd Bank - Korg PA 80 User Manual

9-2 Style Play operating mode

The DIRECT FD bank

Load other Styles into the USER01-USER03 banks. Save
11.
them onto the "!789.SET" folder.
THE DIRECT FD BANK
In addition to the internal memory and DIRECT HD Styles,
you can have DIRECT FD Styles, directly accessed by the
floppy disk.
Just insert a disk, and press the DIRECT FD Style bank. The
disk drive will read the first (in alphabetical order) ".SET"
folder in the floppy disk, and will give you direct access to the
Styles it contains (no loading required).
Note: Reading from floppy disk may take some seconds, before
the Styles are shown.
Browse through the DIRECT FD Styles using the PAGE but-
tons. You can have up to 6 pages, and up to 48 DIRECT FD
Styles in a disk.
Folder
*.SET > STYLE > USER01
*.SET > STYLE > USER02
*.SET > STYLE > USER03
Note: Reading from floppy disk is a little slower than reading
from the internal memory or the hard disk. So, there is a chance
that you will have to wait some beats, before the selected
DIRECT FD Style is ready to play. The Style will enter at the
next beginning of measure.
How to make the DIRECT FD bank
To configure the DIRECT FD bank, save your Styles into the
first folder in the floppy disk. Folders are read in alphabetical
order.
Note: The following procedures requires you overwrite the User
Style banks. Save these banks before proceeding, to avoid loosing
important data.
DIRECT FD pages
1, 2
3, 4
5, 6
Insert the floppy disk into the disk drive.
1.
Press DISK and go to the Load page.
2.
Disk:Load
NEWNAME.SET
LIVE.SET
ETHNICA.SET
FD LOAD
3. Use the F1 (Disk device) button to select the FD (Floppy
Disk) device.
4. Load three banks of Styles, to be transformed into the
DIRECT FD bank.
Go to the Save page.
5.
Disk:Save
ALL
FD SAVE
While the "ALL" item is selected, press F3 (Open) to
6.
open it.
Use the E-F (Scroll Up) and G-H (Scroll Down) VOL-
7.
UME/VALUE buttons (or the TEMPO/VALUE section
controls) to move the "STYLE" item to the first line of
the display, and press F2 (Save).
Select the floppy disk (FD) as the target, using the F1
8.
button.
The floppy disk directory appears. Use the E-F (Scroll
9.
Up) and G-H (Scroll Down) VOLUME/VALUE buttons
(or the TEMPO/VALUE section controls), to scroll the
disk content. Move the first folder of the directory to the
first line of the display.
Press ENTER twice to save the banks.
10.
|
|
OPEN CLOSE
OPEN CLOSE