Powerware Prestige 9 Series User Manual page 64

UPS Operation
54
5. Press and hold the Output On button until the alarm beeps
again.
Two indicators, corresponding with the current setting, remain
flashing. The output voltage is factory-configured for 230V.
OVERLOAD
SITE FAULT
OVERTEMP
BATTERY
SELF TEST
6. Press the Output
voltage options, top to bottom. Each time you press the button,
the UPS beeps and the next two indicators flash.
NOTE If you do not save a selection within two minutes, the setup automatically
aborts and switches back to the original configuration.
7. Press and hold the Output On button until the alarm beeps to
select and save the output voltage. Failure to release the button
immediately after the beep will cause the UPS to abort the
setup.
8. Continue to Step 10.
9. Plug the Y-cord of the PowerPass Module into the power
connectors on the UPS as shown in Figure 22.
10. Press and hold the Output On button until you hear the UPS
beep (approximately one second).

The indicator remains lit and the Self Test indicator turns
on.
Powerware
240V 230V
Figure 23. Output Voltage Indicators
Off button to scroll through the output
9 Prestige Series User's Guide (2500/3000 VA)
®
220V 208V
:
www.powerware.com