Powerware Prestige 9 Series User Manual page 49

Powerware 9 Prestige Series User's Guide (2500/3000 VA)
®
8. Two tie wraps are included with the UPS to secure the Y-cord to
the input and output receptacles on the UPS rear panel. Insert
the tie wrap through the slot on each tie wrap mount.
9. Plug the Y-cord of the PowerPass Module into the power
connectors on the UPS rear panel as shown in Figure 9 or
Figure 10.
10. Verify that the plugs are fully seated.
If power cord locking is required: loop the tie wraps around the
Y-cord connections and tighten to secure the cord to the rear
panel. Allow sufficient slack in the cord between the receptacle
and the tie wrap. At least 12
11. If your PowerPass Module is a plug/receptacle unit, continue to
Step 12. If your PowerPass Module is hardwired, skip to
Step 16.
12. If an Extended Power Distribution Module is required, plug the
EPDM into the power output receptacle on the PowerPass
Module rear panel.
13. The equipment to be protected by the UPS should be powered
off. Plug the equipment into the power output receptacles on
the PowerPass Module rear panel.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
14. If you are using a Remote Emergency Power-Off switch, follow
the instructions in "REPO Installation" on page 34.
15. Start the UPS according to the "UPS with Optional PowerPass
Module Startup" procedure on page 42.
16. Refer to your national and local electrical codes for acceptable
external wiring practices.
Only qualified service personnel (such as a licensed electrician) should perform the
hardwired installation.
17. Remove the three screws on the terminal block access cover
with a Phillips screwdriver and remove the cover (see
Figure 11).
:
www.powerware.com
2
(30 cm) of slack is recommended.
W A R N I N G
Installation
39