Powerware Prestige 9 Series User Manual page 43

OVERLOAD
SITE FAULT
OVERTEMP
BATTERY
SELF TEST
Powerware 9 Prestige Series User's Guide (2500/3000 VA)
®
4. Press and hold the Output On button until the alarm beeps
again.
Two indicators, corresponding with the current setting, remain
flashing. The output voltage is factory-configured for 230V.
When selecting 200V, the UPS is derated to 2500 VA (see the
Model 2500 table on page 67 for 200V specifications).
240V
Figure 5. Output Voltage Indicators
5. Press the Output
voltage options, top to bottom. Each time you press the button,
the UPS beeps and the next two indicators flash.
NOTE If you do not save a selection within two minutes, the setup automatically
aborts and switches back to the original configuration.
6. Press and hold the Output On button until the alarm beeps to
select and save the output voltage. Failure to release the button
immediately after the beep will cause the UPS to abort the
setup.
7. Continue to Step 9.
8. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with NEC specifications or national wiring rules.
9. Turn on the equipment that is connected to the UPS.
10. Press and hold the Output On button until you hear the UPS
beep (approximately one second).
:
www.powerware.com
230V 220V
Off button to scroll through the output
Installation
208V 200V
33