Ups Startup - Powerware Prestige 9 Series User Manual

Installation

UPS Startup

To start up the UPS:
32
9. Verify that the load plug is fully seated.
If power cord locking is required: loop the tie wrap around the
power cord and tighten to secure the cord to the rear panel.
Allow sufficient slack in the cord between the receptacle and
the tie wrap. At least 12
10. The equipment to be protected by the UPS should be powered
off. Plug the equipment into the output receptacle power strip
or EPDM.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
11. If you are using a Remote Emergency Power-Off (REPO)
switch, follow the instructions in "REPO Installation" on
page 34.
12. Start the UPS according to the following "UPS Startup"
procedure.
1. Plug the UPS power supply cord into the input connector on
the UPS rear panel.
If power cord locking is required: loop the tie wrap around the
power cord and tighten to secure the cord to the rear panel.
Allow sufficient slack in the cord between the receptacle and
the tie wrap. At least 12
NOTE Steps 2 through 7 are for changing the output voltage. The output voltage is
factory-configured for 230V. If you do not need to change the output voltage, skip to
Step 8.
2. Plug the other end of the power supply cord into a grounded,
three-wire, AC receptacle that has been wired in accordance
with NEC specifications or national wiring rules.
3. Press the Output
All indicators flash simultaneously.
Powerware
2
(30 cm) of slack is recommended.
2
(30 cm) of slack is recommended.
Off button until the alarm beeps.
9 Prestige Series User's Guide (2500/3000 VA)
®
:
www.powerware.com