Powerware Prestige 9 Series User Manual page 48

Installation
Tie Wrap Mount
Power
Input
Connector
Battery
Connector
Input Circuit
Protector
Battery
Circuit
Breaker
Breaker
Tie
Battery
Cabinet
Battery Cord
38
REPO Receptacle Serial Port
External Battery
Connector
Figure 10. UPS with PPIM Rear Panel
NOTE You can install additional battery cabinets while the UPS is operating, but
confirm the UPS is not in Battery mode (see page 47).
3. Verify the circuit breaker on all battery cabinets is in the
OFF (O) position.
4. Remove the battery connector guard. Plug the battery cord into
the external battery connector on the UPS. All battery
connectors are polarized to prevent incorrect connection.
5. If additional battery cabinets are to be used, plug the battery
cord of the second cabinet into the external battery connector
of the first battery cabinet. Follow this procedure for each
additional battery cabinet.
6. Remove the breaker tie from the circuit breaker on all battery
cabinets.
7. Switch the circuit breaker on all battery cabinets to the ON (
position.
Powerware
UPS Cabinet
Power Output Receptacle
and Tie Wrap Mount
Y-Cord Output
Breaker
Utility Input Input
Connector Breaker
9 Prestige Series User's Guide (2500/3000 VA)
®
Bypass
Switch
PPIM
(50 Hz)
Power Output
Receptacles
)
|
:
www.powerware.com