Step 2 - Positioning The Projector; Step 3 - Connecting A Source - Christie M Series Setup Manual

6. Use a 5mm hex driver to fasten the red security screws provided with the lens mount (Figure 2-5 ), or hand
tighten the lens retaining screws attached to the lens (Figure 2-6 ). NOTES: 1) Recommended for heaviest
lenses such as 0.73:1 and 1.2:1. 2) The red security screws MUST be installed when hoisting the
projector overhead, or installing the projector in an overhead position.

STEP 2 - Positioning the Projector

Place the projector on a sturdy, level surface and position it so that it is perpendicular to the screen at a suitable
distance. The further back the projector is positioned for the screen, the larger the image will be.
To level the projector adjust its 3 feet. With the projector positioned perpendicular to the screen the image will
appear rectangular instead of keystoned.

STEP 3 - Connecting a Source

Located at the back of the projector is the input panel where all source connections are made. Each input is
clearly labeled for easy identification. Depending on the type of option card installed, connect your source
using the appropriate cable(s), as follows:
• Analog Input Card, connect 3-, 4-, or 5-wire RGB source to Red/Pr, Green/Y, Blue/Pb, H/C and V using 3,
4 or 5 BNC connectors as required.
• Dual SD/HD - SDI Input Card, connect SDI (Serial Digital Interface) cable to one of the two inputs, 1-IN
or 2-IN. Both standard-definition (SD) and high-definition (HD) signals are accepted and automatically rec-
ognized on either input.
• Dual Link DVI Input Card, connect a single or dual DVI video signal to the DVI-I connector, an analog
video signal to the DVI-I connector or an analog video signal to the VGA connector. The DVI signal may
contain HDCP (High-Bandwidth Digital Content Protection).
• Twin HDMI Input Card, connect HDMI (High-Definition Multimedia Interface) cable to one of the two
inputs, 1-IN or 2-IN.
M Series Setup Guide
020-100011-04 Rev. 1 (07-2010)
F 2-5
IGURE
Use of the lens red security screws or the lens retaining screws is required if the
projector is hoisted or installed in an overhead position.\
2 people are required to safely lift and install the projector.
Section 2: Installation and Setup
F 2-6
IGURE
2-3