On-Line Help; The Global Icon; Using Slide Bars And Other Controls - Christie M Series Setup Manual

When finished with a Function menu:
• Press E to return to the previous screen.
XIT
OR
• Press M
to leave the menu system and return to the presentation.
ENU
If there is no signal present, all source-dependent adjustments are disabled.
NOTES: 1)
of inactivity, the projector leaves the menu system and returns to the presentation.
read-only.

On-line Help

Press H to display summary information about the current menu or highlighted option. Press H
ELP
exit.

The Global Icon

Menu options that include this icon apply universally. Menu options without this icon apply to the
selected channel only.

Using Slide bars and Other Controls

Most of the function menus allow you to change settings by using slide bars, checkboxes, and pull-down lists.
Navigating options:
• Enter the menu option number corresponding to the setting you wish to change (for example, press M
to select "Vertical Stretch" in the Size and Position menu).
• Move the highlight to the option desired and press E
• Move the highlight to the option desired and press L
• You can bypass the menus entirely and use a single key to immediately access an adjustment during your
presentation (applies only to options having their own key, such as Contrast, Brightness, Gamma, etc.).
• For "blind" access, hide the entire menu system (see OSD key, above) and access using the proper sequence
of key presses.
M Series Setup Guide
020-100011-04 Rev. 1 (07-2010)
F 3-5 O -L H
IGURE N INE ELP
.
NTER
/R
EFT IGHT
Section 3: Operation
The Status menu is
3)
A K to adjust immediately.
RROW EY
After 15 minutes
2)
again to
ELP
1 3
ENU
3-9