Channel; Slot 1, 2, 3, 4; Input; Pip - Christie M Series Setup Manual

The best auto setup will be obtained under the following conditions:
• Input levels, it is best to have an image with saturated (very bright) colors.
• Phase, high contrast edges are needed.
To determine active window size:
• Video images should have whites and blacks in the image.
• Wide range video images should have content (including white) that extends to all edges of the image.

Channel

Select a specific source setup (channel) defined and stored in projector memory. Once you enter a two-digit
channel number (or, if there is a list displayed, highlight it and press E
change and update according to the numerous setup parameters defined for that channel.
channel is automatically created if you adjust an image from a new source.
C
NOTE: HANNEL
option is enabled in the Menu Preferences menu. You can choose to use a scrollable list of channels when
you press C
HANNEL
feedback. See Menu Preferences later in this section.

Slot 1, 2, 3, 4

Press to display the next active input on the card in the slot.

Input

Displays all inputs in all slots, both active and inactive. Scroll through the list to select an input for the main
image. Press Input again to show the list and select the picture-in-picture (PIP) image.

PIP

Turns PIP ON or OFF.

Swap

Swaps the main and PIP images.

Contrast

Changes the level of peak white in your images. Use L
of contrast—for best results, start low and increase so that whites remain bright but are not distorted or tinted
and that light areas do not become fully white (i.e., "crushed"). Conversely, low contrast causes dim images.

Bright

Increases or decreases the black level in the image. Use L
level of brightness. For best results, start high and decrease so that dark areas do not become fully black (i.e.,
"crushed"). Conversely, overly high brightness changes black to dark gray, causing washed-out images.
M Series Setup Guide
020-100011-04 Rev. 1 (07-2010)
key behavior during a presentation depends on whether or not the Display Channel List
, or you may prefer to enter the desired channel number "blind", i.e., without on-screen
), the display will automatically
NTER
/R A K until you reach the desired level
EFT IGHT RROW EY
/R A K
EFT IGHT RROW EY
Section 3: Operation
A new
NOTE:
until you reach the desired
3-5