4 Replacement Procedures
4.17 RGB harness holder / RGB board / Modem jack
Removing the RGB harness holder / RGB board / Modem jack
To remove the RGB harness holder / RGB board / modem jack, follow the steps below and refer
to Figure 4-32 to 4-34.
1. Remove the following screw securing the RGB harness holder.
?
M2.5? 4B
2. Take out the RGB harness holder while unhooking the front latches.
4-52
4.17 RGB harness holder / RGB board / Modem jack
FLAT HEAD screw
RGB harness holder
Figure 4-32 Removing the RGB harness holder
? 1
M2.5? 4B FLAT HEAD
TECRA M3 Maintenance Manual (960-507)