Toshiba TECRA M3 Maintenance Manual page 344

4 Replacement Procedure
Removing the screws
1. Remove the lamp clip (Reuse it).
2. Spread out the insulation sheet without detaching it from the side of the bezel, as shown in
Figure 4-70.
3. In the order (1) and (2) shown in Figure 4-70, remove the screws from the left- and right-
hand sides of the module.
CAUTION: (1) To unfasten the screws, use an insert bit of point size 0 for Philips
screwdrivers.
(2) Leave the insulation sheet on the bezel to allow the reuse of the sheet.
Figure 4-70 Replacing TMD fluorescent lamp (XGA) (2)
4-98
Insulation sheet
Product Label
Lamp clip
TECRA M3 Maintenance Manual (960-507)
4.26 Fluorescent Lamp