Toshiba TECRA M3 Maintenance Manual page 298

4.17 RGB harness holder / RGB board / Modem jack
Installing the RGB harness holder / RGB board / Modem jack
To install the RGB harness holder / RGB board / modem jack, follow the steps below and refer to
Figure 4-32 to 4-34.
1. Connect the RGB harness to the connector CN5622 on the RGB board.
2. Install the RGB board while inserting the RGB connector to the slot.
3. Secure the RGB board with the following screw.
?
M2.5? 2.8B
4. Install the modem jack to the slot.
5. Stick the glass tape .
6. Install the RGB harness holder while hooking the front latches.
7. Secure the RGB harness holder with the following screw.
?
M2.5? 4B
CAUTION: Route correctly the modem jack cable and RGB harness in the slot as shown
below.
TECRA M3 Maintenance Manual (960-507)
FLAT HEAD screw
FLAT HEAD screw
Modem jack cable
Gasket
4 Replacement Procedures
? 1
? 1
RGB harness
4-55