4.10 Modem Daughter Card (MDC)
Installing the Modem Daughter Card
To install the modem daughter card, follow the steps below and refer to Figure 4-21.
1. Connect the MDC cable to the connector on the modem daughter card.
2. Seat the modem daughter card and press carefully on the card to connect it to the
connector CN3000 on the system board. Be careful not to damage the card and connector.
3. Secure the modem daughter card with the following screws .
?
M2? 4Z
TECRA M3 Maintenance Manual (960-507)
? 2
BIND screw
4 Replacement Procedures
4-35