Toshiba TECRA M3 Maintenance Manual page 221

3.31 SETUP
NOTE: 1. The Network Boot Protocol is not displayed in Gigabit LAN models.
2. The item of Language During Boot up is only for TCL model.
3. The SECURITY CONTROLLER window is displayed when the SETUP is
booted during IRT.
Moving Within the SETUP Menu and Changing Values
1. Press ? and ? to move between the two columns. Press ? and ? to move between items
in a column. Press Fn+? ??PgUp) and Fn + ? ??PgDn) to move between the two pages.
2. Press either the Space bar or Back Space to change the value.
Accepting Changes and Exiting the SETUP Window
1. Press End to accept the changes you made.
If the changed item does not require the system to reboot, the following message is
displayed:
Are you sure? (Y/N)
If the changed item requires the system to reboot, the following message is displayed:
Are you sure? (Y/N)
The changes you made will cause the system to reboot.
2. To make other changes, press N. Repeat the steps above.
3. To accept the changes, press Y.
You can press Esc to quit at any time without saving changes. SETUP asks you
Note:
to confirm that you do not want to save your changes. When SETUP is displayed
at the next time, the current configuration appears.
TECRA M3 Maintenance Manual (960-507)
3 Tests and Diagnostics
3-93