Pressure Sensor - Renault 2000 Megane Technical Note

PRESSURE SENSOR (1)

YOU SHOULD FOLLOW THE CLEANNESS
INSTRUCTIONS CLOSELY.
REMOVAL
Disconnect the battery.
Remove the sensor connector.
Unscrew the pressure sensor.
After any intervention, check that there are no leaks in the diesel circuit.
Start the engine at idling speed until the fan starts up, then accelerate
several times under no load.
DIESEL EQUIPMENT
Pressure sensor Pressure sensor
TIGHTENING TORQUES (In daN.m or/and°)
Pressure sensor
IMPORTANT: before any intervention, connect
the after-sales diagnostic tool, query the injection
computer and check that the injection rail is not
under pressure. Take note of the fuel temperature.
13-38
3.5 ± 0.5
REFITTING
Replace the seal.
Screw in the sensor then tighten it to torque.
Connect the connector.
13
16192R2