Pressure Regulator - Renault 2000 Megane Technical Note

PRESSURE REGULATOR (2)

YOU SHOULD FOLLOW THE CLEANNESS
INSTRUCTIONS CLOSELY.
REMOVAL
Disconnect the battery.
Remove the regulator connector.
Remove the retaining bracket for the diesel
temperature sensor.
Unscrew the regulator mounting bolts.
Remove the regulator by turning in an anticlockwise
direction (do not use any tools as a lever when
removing the pump regulator).
After any intervention, check that there are no leaks in the diesel circuit.
Start the engine at idling speed until the fan starts up, then accelerate
several times under no load.
DIESEL EQUIPMENT
Pressure regulator Pressure regulator
TIGHTENING TORQUES (In daN.m or/and °)
Regulator bolt
IMPORTANT: before any intervention, connect
the after-sales diagnostic tool, query the injection
computer and check that the injection rail is not
under pressure. Take note of the fuel temperature.
13-39
0.9 ± 0.1
REFITTING
Change the seals.
Dampen the seals with clean diesel.
Replace the regulator in the pump by turning it in an
anticlockwise direction (do not use any tools as a lever
when replacing the pump regulator).
Fit the mounting bolts then tighten to torque.
Connect the connector.
13