Renault 2000 Megane Technical Note page 66

DIESEL EQUIPMENT
13
Injection/air conditioning programming
COMPRESSOR OPERATION PROGRAMMING
During certain stages of operation, the diesel injection computer stops the compressor from functioning.
Engine start programming
The compressor is prevented from operating for 5 seconds after the engine has started.
Recovery of performance
When the position of the accelerator pedal is changed significantly and if the engine speed is less than 3000 rpm,
the compressor is prevented from operation for 5 seconds.
Recovery of output when the vehicle starts moving
If the position of the potentiometer is more than 50 % the engine speed is less than 2250 rpm and the vehicle speed
is below 20 km/h, the compressor is cut for 5 seconds.
Anti-stall protection
If the no load position is not detected, and the engine speed is less than 675 rpm. the compressor is disengaged. It
is engaged again after 5 seconds if the engine speed is increased.
Thermal protection programming
The compressor does not engage in cases where the coolant temperature is greater than + 112 °C.
13-15