Exhaust; Catalytic Converter - Renault 2000 Megane Technical Note

TIGHTENING TORQUES (in daN.m)
Engine tie bar bolt
Steering shaft yoke bolts
Engine sub-frame bolts
– front ∅ 10
– rear ∅ 12
Three point flange nuts
Sub-frame - side member tie rod bolts
Disconnect the battery and put the vehicle on a two
post lift.
Fit a flywheel immobiliser.
Loosen the catalytic converter/precatalytic converter
mountings.
Fit tool Tav. 1233-01 replacing the bolts of the sub-
frame one by one.

EXHAUST

EXHAUST 1419

Catalytic converter

Catalytic converter
6.2
3
6.2
10.5
2
3
Remove:
– the bolts of the sub-frame tie-rods,
– the nut and eccentric bolt of the steering shaft
yoke (1),
– the torque reaction arm.
Lower the sub-frame to a height of 40 mm at the front
and 60 mm at the rear.
Remove the exhaust mounting clip.
Remove the mounting nuts of the catalytic converter
and remove it, taking care not to damage the heat
shields.
REFITTING
Proceed in the reverse order from removal.
WARNING: all damaged heat shields must be
replaced to prevent the risk of fire.
15870R
19-7
19
97390-1R2