Attaching The Front Door To The Chassis - Cisco Nexus 7706 Hardware Installation Manual

Installing the Switch Chassis
What to Do Next
You are ready to attach the optional door to the cable management frames.

Attaching the Front Door to the Chassis

Before you can attach the optional front door to the chassis, you must attach a door-stop bracket to the bottom
of the cable management top hood.
Optionally, you can install an air filter inside the door and brush filters to the sides of the door and to the sides
of the cable management assemblies (see
34).
Before You Begin
• Verify that the cable management frames are attached to the chassis.
• Verify that you have the following tools and equipment:
Step 1 Attach the metal door-stop bracket to the top hood as follows:
a) Place the metal door bracket under the top hood of the cable management system and align with the two screws on
the metal bracket with two holes on the bottom of the top hood (see the following figure).
Figure 17: Attaching the Door Stop
1 Top hood
OL-31330-01
◦ Optional front door kit
◦ Door stop bracket
◦ Front door
◦ Number 1 manual Phillips torque screwdriver

Attaching the Front Door to the Chassis

Installing Cable Management Frames onto the Chassis , on page
3 Align the bracket screws to two screw holes in the
top hood
Cisco Nexus 7706 Hardware Installation Guide
37