Connecting Ac Power Supplies To Power Sources - Cisco Nexus 7706 Hardware Installation Manual

Installing the Switch Chassis
The following figure shows the location of the grounding pad on the front of the chassis. There is another grounding pad
on the other side of the chassis.
Figure 13: Grounding Pad Location on the Front of the Cisco Nexus 7706 Chassis
1 Grounding pad
Step 5 Prepare the other end of the grounding wire and connect it to an appropriate grounding point in your site to ensure an
adequate earth ground for the switch. If the rack is fully bonded and grounded, connect the grounding wire as explained
in the documentation provided by the vendor for the rack.

Connecting AC Power Supplies to Power Sources

Connect each installed AC power supply with a AC power circuit as follows:
OL-31330-01

Connecting AC Power Supplies to Power Sources

Cisco Nexus 7706 Hardware Installation Guide
31