Installing Or Replacing A Fabric Module - Cisco Nexus 7706 Hardware Installation Manual

Installing or Replacing Modules, Fan Trays, and Power Supplies
Two alignment pins on the top and two alignment pins on the bottom should align to holes at the top and bottom of
the fan tray slot.
Figure 26: Installing a Fan Tray
1 Hold both handles with both of your hands.
c) Screw in each of the four captive screws to secure the fan tray to the chassis and tighten them to 8 in-lb (0.9 N·m)
of torque.
Step 3 Verify that the fan tray is functioning by making sure that its Status LED is green.
For more information about the fan tray LEDs, see the

Installing or Replacing a Fabric Module

The fabric modules are located as follows behind the fan trays on the back side of the chassis:
• Fabric slots 1 and 2 are behind fan tray slot 1
OL-31330-01
Installing or Replacing a Fabric Module
2 Position the alignment pins at the top and bottom
of the fan tray to alignment holes in the chassis and
press the fan tray into the slot.
I/O Module LEDs, on page 118
Cisco Nexus 7706 Hardware Installation Guide
topic.
83