Connecting To A Module - Cisco Nexus 7706 Hardware Installation Manual

Connecting to a Module

xbar-2 Intake
xbar-2 Crossbar(s3)
switch#
Connecting to a Module
At any time, you can connect to any module by using the attach module command. Once you are at the
module prompt, you can obtain further details about the module by using module-specific commands in EXEC
mode.
You can also use the attach module command to display the standby supervisor module information, although
you cannot configure the standby supervisor module using this command.
Step 1
Enter the attach module slot_number command.
Example:
switch# attach module 4
switch(standby)#
Provides direct access to the specified module (in this example, the standby supervisor module is in slot 6).
Step 2 dir bootflash
Example:
switch(standby)# dir bootflash
Example:
switch# dir bootflash:
80667580
22168064
16384
Usage for bootflash://sup-local
234045440 bytes used
1684602880 bytes free
1918648320 bytes total
switch#
Provides the available space information for the standby supervisor module.
To exit the module-specific prompt, use the exit
Note
command.
If you are not accessing the switch from a console terminal, this step is the only way to access the standby
Tip
supervisor module.
Cisco Nexus 7706 Hardware Installation Guide
56
(s2) 62
105
Feb 21 22:04:59 2008 is855.S7
Feb 21 22:04:19 2008 ks855.S7
Jan 03 19:56:00 2005 lost+found/
42 31 Ok
95 56 Ok
Managing the Switch
OL-31330-01